For the operation of certificated machinery, any individual wishing to install and operate this machinery must obtain a Permit-to-Install (PTI) as required under the provisions of Section 36(1), Factories and Machinery Acts 1967, where each owner/owner/occupant or resident of a workplace and general installation is required to obtain a Permit-to-Install in writing from the Factories and Machinery Inspector, before a general installation of a machinery and also a certificated machinery is installed and a Certificate of Fitness is obtained as in section 19 (1) of the Factories and Machinery Act.
FOR FURTHER ENQUIRIES
Please contact the state office of Department of Occupational Safety and Health (DOSH) regarding the application. DOSH Staff Directory
folder Factories and Machinery Act 1967
- Application for registration of factories and certificated machinery is done online through MyKKP at http://mykkp.dosh.gov.my
- Panduan Pendaftaran melalui MyKKP Registration Guide using MyKKP here.
- All statutory inspection charges are based on the charge rate which has been set according to the new rate as in the Factories and Machinery (Notification, Certificate of Fitness and Inspection) (Amendment) Regulations 2004.
Please refer to MyKKP's guide on application categories related to information and documents required for the registration of each category of certificated machinery through the method below:
GUIDE > FACTORY AND MACHINERY > MACHINERY (please select the registration category you wish to register) . http://mykkp.dosh.gov.my/Default.aspx